Please do not attempt to follow my steps as most likely you will end up bricking your Xbox, I am merely stating my experience for information purposes only.
Having seen a number of videos and forums on the topic, I decided to buy an Xbox 360 with the Red Ring of Death off eBay and attempt to fix it. Why? I guess because I like taking gadgets apart and seeing how they work. I used to fix many an iPod back in the day and it was actually quite profitable at one point. Anyway, here is what has happened so far, I have made my own conclusions at the moment but, I admit, they may seem absurd and there is certainly nothing scientific about what I have done.
Having received the Xbox 360 from the eBay seller, I tried to determine the secondary error code. So I held down the connectivity button, whilst pressing the eject button four times. 4 Rings Flashed (0), 4 Rings Flashed (0), 2 Rings Flashed (2) and 4 Rings Flashed. This gives me the error code 0020. I googled this code and found out that is an unknown code, but the error is most likely caused by overheating.
To find out more about error codes, check out this site: Xbox 360 Error Codes
Ok, as you know I did the Penny trick using the following 2 videos to assist me and the 360 was working fine.
How to fix the RROD PERMANENTLY!!!! -- By sirbamalot
How To Take Apart Xbox 360 -- By Robert941
I played a few hours of games, watched a dvd -- absolutely no problem. However as I was using the 360 to PC connection cable in my bedroom, where the PC is, it was a pain in the ass connecting and disconnecting the PC cable every time (you know the blue one with all the pins in it and the two connecting screws, one at either side). Anyhoo, I therefore bought an official (used) 360 component cable off eBay.
Having connected this cable, after less than an hour’s gameplay, the 360 had crashed several times. When it crashed the game froze, stripes appeared down the screen, the colour went a bit red and after about 3 times of doing this, the RROD were back.
A little annoyed but not beaten at this point, I disassembled the 360 again, checked the fans were working and found one of the Penny stacks had come a bit loose, it was still in place as it is squashed down there but I was able to move it, whereas the other 3 were stuck solid. Aha, I thought so I restuck it and re-assembled the 360.
I had to do the towel trick which I am not a great fan of, but seemed like the only way to reset the console. Plugged it back in after it had suitably cooled, and it worked -- for about 2 mins!
Getting a bit annoyed, I stipped it down again made sure everything was ok (as far as I could tell) -- double checked all the penny stacks, and re-assembled. Did the towel trick again, and it started making strange noises after about 15 minutes (ooh this can’t be good) so disconnected it and left it to cool again.
This time I reconnected the 360 to PC cable, and it worked. It has now been on for about an hour, I have left a DVD running just now. No crashes or RROD so far (touch wood!).
My question to you is this, do you think that a different chip (or something) could be used depending on whether you use Component output or PC output? Could it be, if these chips exists, my Component output chip is goosed? Or is this a ridiculous thought?
I am now wary of plugging in the component cable again, I suppose I could test the theory but what if I permanently goose the 360, as that towel trick really can’t be good for all the components inside!
PS -- it’s still runnning…(fingers crossed)
Watch this space for more updates…


